Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Mount Washington?
Spring replacement in Mount Washington typically runs $210 – $400 for a single torsion spring, including the spring, the labor, and a balance check on the door. If your door uses two springs, and most newer doors do, both are usually swapped at the same time, so a matched pair lands around twice that: roughly $420 – $800. The written estimate you get on site sets the final price, and there’s no charge for that estimate.
A snapped spring is the most common reason a garage door stops working, and it’s also the repair most likely to go wrong in untrained hands. Garage door springs are under extreme tension. This is not a DIY repair, and we’d rather talk you out of a hardware-store spring than hear about an injury. Call (855) 525-7051 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.
We connect Mount Washington homeowners with independent local professionals who are licensed and insured as their state requires. Our technicians have up to 14 years of experience, and they’re certified to service eight widely installed brands, including LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor. That matters here because Mount Washington’s housing stock is a mix of older brick colonials and postwar builds, and those doors were fitted with whatever hardware was standard at the time. We work on the brand you already have.
Key Takeaways
- One torsion spring: typically $210 – $400. A matched pair: about twice that.
- Extension springs (common on older doors) sit at the lower end of the range.
- Most spring jobs are a single visit. The door gets rebalanced before we leave.
- Same-day service is available for doors that won’t open or won’t close.
- Free estimates, and the written quote is the price.
Spring Replacement Cost Breakdown (2026)
Here’s how the numbers break down for a typical Mount Washington spring job. These are estimated ranges for the local market in 2026, not a quote. Your written estimate is what counts.
| What’s Being Done | Typical Estimated Range |
|---|---|
| Spring repair (one spring) | $210 – $400 |
| Matched pair, torsion springs | About twice the single-spring range |
| Garage door repair (broader mechanical work) | $175 – $710 |
| Cable repair (often needed alongside springs) | $155 – $295 |
| Roller replacement | $130 – $260 |
| Track realignment | $140 – $285 |
| Panel replacement | $295 – $590 |
| Opener repair | $140 – $380 |
| Opener installation | $295 – $650 |
| New door installation | $825 – $2595 |
What pushes a spring job toward the top of the range? The spring type and size matter first. A heavy torsion spring on a double-car door costs more than the lighter pair on a single door, simply because the wire gauge and coil count go up. Second, condition of the surrounding hardware. Springs and cables wear out together, and when the cable is frayed or the drum is scored, replacing the spring alone is a short-lived fix. Third, the door itself. A wood door that’s absorbed moisture over many wet Mid-Atlantic summers weighs more than its original spring was ever sized for, which means we may need to step up a size rather than match what’s there. Fourth, access. A low-headroom setup or a door with a bulky storage rack overhead takes more time to work around safely.
Where a job lands at the lower end: a single extension spring on an older single-car door, with cables and rollers in decent shape. Those are fast, straightforward replacements. If you want to understand how the whole job works before anyone arrives, our spring replacement page walks through it.
What Affects Spring Replacement Pricing in Mount Washington
- Spring type. Torsion springs mount on a shaft above the door and do most of the lifting on modern doors. Extension springs run along the sides and are common on older Mount Washington garages. Torsion replacements usually cost more because there are two of them and the tensioning is more involved. Both are a professional job.
- One spring or two. A door with two torsion springs is designed so each can carry the load if the other fails. They’re replaced as a pair because a fresh spring next to an aged one puts uneven stress on the shaft. Budget for two if that’s what you have.
- Door weight and material. Mount Washington’s older homes often have original wood doors, and wood gains weight with seasonal humidity. Steel and aluminum doors with insulation sit in a predictable range. Heavier doors need heavier springs, and that costs more.
- Cycle life of the replacement. Springs are rated by how many open-and-close cycles they’ll last. A standard spring is the budget choice. A high-cycle spring costs more upfront and lasts longer, which is worth considering on a door that opens several times a day.
- Condition of cables, drums and bearings. If the spring failed, the cables took a shock. If they need replacing too, expect the cable repair range of $155 – $295 on top. We check this before quoting so there are no surprises.
- Access and headroom. Tight side clearance, a low ceiling, or a car parked in a way that blocks the work zone all add time to the job. Most Mount Washington garages are straightforward, but older detached garages with low headroom take longer.
One thing that doesn’t vary: the price isn’t higher because the door failed on a Sunday or because you need it handled today. Same-day work is scheduled the same way as anything else, and the price is set per job by the written estimate.
How to Save on Spring Replacement
The biggest savings lever is catching the problem before collateral damage. A spring that’s about to fail usually gives warning: the door gets heavier to lift, the opener strains, or you hear a bang from the garage. Getting it looked at then is a spring job. Waiting until it snaps often means a cable or drum goes with it, and that’s a second line item on the estimate.
A few other things that help:
- Fix the springs before the opener pays for it. When a spring weakens, the opener works harder to lift the door. That burns out the motor and the gears, and a new opener runs $295 – $650 installed. Replacing a spring on time is the cheaper order of operations.
- Ask about replacing the pair. If your door has two springs and one has failed, replacing both is usually better value than paying for two separate visits later.
- Get the whole door checked in one visit. Rollers, hinges, and the balance of the door are all quick to assess while the technician is there. Catching a worn roller at $130 – $260 beats a track realignment later.
- Don’t buy the spring online and ask for labor only. Springs have to match the door’s weight and drum size, and the wrong one fails early or damages the door. A proper replacement includes sizing, tensioning, and a balance test.
- Ask for the estimate in writing. Free estimates mean you can compare like for like, and the written quote is what you pay.
If a spring has already snapped and the door is stuck, call (855) 525-7051. We answer 24/7. A call outside dispatch hours is booked into the next opening, Sunday through Friday, 7am to 7pm. Mount Washington Garage Door Repair handles the full range, from a snapped spring to a full new door installation, so you don’t need to find a second company if the estimate turns up something bigger. For general repair work beyond the springs, our Mount Washington Garage Door Repair page covers what we take on.
Why Spring Work Is a Specialist Job
Torsion springs hold the entire weight of the door under tension, and releasing that tension safely takes specific tools and a specific order of operations. A spring that lets go under load can cause serious injury, which is why we treat spring repair as its own dedicated service rather than an add-on to general handyman work. A generalist may have replaced a spring before; the technicians we connect you with do it as a core part of their work, on the specific brands in your garage.
That brand familiarity matters more than homeowners expect. A Wayne Dalton door has different spring geometry from a Clopay, and a Raynor from an Amarr. Knowing the hardware before arrival means fewer return visits and a door that’s balanced correctly on the first try. We service LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman, and Raynor equipment, and if your opener has been straining against a weak spring, we can assess and repair that in the same visit as the spring replacement. Most opener issues are diagnosed and resolved in a single visit.
FAQs – Spring Replacement Cost
How much does spring replacement cost in Mount Washington?
Spring replacement in Mount Washington typically costs $210 – $400 for one spring, and about twice that for a matched pair. The estimate is free, and the written quote sets the final price. Call (855) 525-7051 for an exact figure.
Is it cheaper to repair the spring or replace the door?
Repairing the spring is much cheaper in almost every case: $210 – $400 against $825 – $2595 for a new door. A new door only makes sense when the panels, tracks, or structure are beyond economical repair. A failed spring alone never justifies a replacement. Call (855) 525-7051 and we’ll tell you honestly which one you’re looking at.
Can you come today if my spring broke?
Yes, same-day service is available. A door that won’t open or is trapping a vehicle is exactly what our emergency service is for. Call (855) 525-7051. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Do both springs need replacing if only one broke?
Usually yes. Two-spring doors are replaced as a pair because a new spring beside an old one wears unevenly and can fail early, and the pair costs about twice the single-spring range. We’ll explain the reasoning on site. Call (855) 525-7051 for a free estimate.
Does the price go up for emergency or same-day work?
No. The price is set per job by the written estimate, and a same-day or urgent repair isn’t charged a premium. Emergency service is part of what we offer, not an upsell. Call (855) 525-7051 to get an estimate started.
What if the spring looks fine but the door still feels heavy?
A heavy door usually means the spring is losing tension or the door needs rebalancing, and a balance check is part of any spring job. Rollers and cables can also contribute, at $130 – $260 and $155 – $295 respectively. Call (855) 525-7051 and we’ll narrow it down.
How long does a spring replacement take?
Most single-visit spring jobs are done in a couple of hours, including the balance test. If cables or drums need work too, expect longer. The written estimate will lay out exactly what’s included before anything starts. Call (855) 525-7051 to book.
Get a Free Spring Estimate in Mount Washington
If your door is struggling to lift, making noise from the shaft, or already stopped with a snapped spring, the sooner it’s assessed the less it tends to cost. Mount Washington Garage Door Repair offers free estimates, a written price, and same-day service when a door fails. We work on the brands you already have, diagnose the opener and door together, and won’t push a replacement you don’t need. Call (855) 525-7051. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Mount Washington Garage Door Repair.
Pricing reflects the Mount Washington market as of 2026. Mount Washington Garage Door Repair offers free estimates – call (855) 525-7051.
What Our Customers Say
"Door installed in about four hours, old one hauled away, and he stayed to program both cars and the wall panel before he left."
- Imani Freeman"Keypad stopped working, which I assumed meant a whole new system. It was the batteries and a reprogram. He charged me the minimum service call and told me how to do it myself next time."
- Sarah Padgett"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Danika Dawson